In the Source Interface and Destination Interface drop-down lists, choose the appropriate interfaces.Click Advanced in order to select the source and destination interfaces. Click OK in order to add the NAT rule.Choose the configured NAT rule and change the Translated Addr to be the newly configured group 'nat-pat-group' (was previously 'obj-my-range').In the Group Name field, enter a group name and add both address objects (NAT range and PAT IP address) in the group. Click Add to add a network object group.In the IP Address field, enter the PAT backup IP address. Repeat steps 1 to 3 in the previous configuration and click Add once again in order to add a network object.As a result, you could try to implement dynamic NAT with dynamic PAT backup or you could try to expand the current pool. If the mapped pool has fewer addresses than the real group, you could run out of addresses. This is the equivalent CLI output for this ASDM configuration: object network obj-my-rangeĪs per this configuration, the hosts in the 172.16.11.0 network get translated to any IP address from the NAT pool, 203.0.113.10 - 203.0.113.20. In the Translated Addr field, choose the address object.In the Start Address and End Address fields, enter the starting and ending PAT IP addresses. In the Type drop-down list, choose Range. In the Translated Addr field, choose the appropriate selection. In the Type drop-down list, choose Dynamic. ![]() ![]() Check the Add Automatic Address Translation Rules check box. In this example, the entire inside-network has been selected.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |